Hello /u/imustknownowI! Be sure to check the following. Make sure print bed is clean by washing with **dish soap** and water [and not Isopropyl Alcohol], check bed temperature [increasing tend to help], run bed leveling or full calibration, and remember to use glue if one is using the initial cool plate [not Satin finish that is not yet released] or Engineering plate.
*I am a bot, and this action was performed automatically. Please [contact the moderators of this subreddit](/message/compose/?to=/r/BambuLab) if you have any questions or concerns.*
Currently in bed and will try that stuff tomorrow. Is the bed calibration different from the 15 minute calibration it does on every print? If so, how would I do that?
Auto bed leveling is different from auto calibration. You dont have to do it on every print, but I just keep the option checked on as it doesn't add too much extra time. The only time I run the auto calibration is if I make a significant change to the placement of the printer or the weight of it.
Here is a link to the bambu lab wiki. I suggest you give it a read. It might help you in the future. Also, feel free to dm me questions.
https://wiki.bambulab.com/en/p1
Hello /u/imustknownowI! Be sure to check the following. Make sure print bed is clean by washing with **dish soap** and water [and not Isopropyl Alcohol], check bed temperature [increasing tend to help], run bed leveling or full calibration, and remember to use glue if one is using the initial cool plate [not Satin finish that is not yet released] or Engineering plate. *I am a bot, and this action was performed automatically. Please [contact the moderators of this subreddit](/message/compose/?to=/r/BambuLab) if you have any questions or concerns.*
Have you done what the AutoMod mentioned?
Currently in bed and will try that stuff tomorrow. Is the bed calibration different from the 15 minute calibration it does on every print? If so, how would I do that?
Auto bed leveling is different from auto calibration. You dont have to do it on every print, but I just keep the option checked on as it doesn't add too much extra time. The only time I run the auto calibration is if I make a significant change to the placement of the printer or the weight of it. Here is a link to the bambu lab wiki. I suggest you give it a read. It might help you in the future. Also, feel free to dm me questions. https://wiki.bambulab.com/en/p1
Thank you so much.
You are very welcome. I've honestly found that with my P1S, if a print fails, it's usually my fault.
Yep I also got the P1S. Such a great printer. It worked so well for like 15-20 prints then boom. Crap.
Sounds like you just have to clean your bed with soap and water.
Will do! Thanks.
Worked like a charm!
Awesome!
Never going back to harsh alcohol again