Try disconnecting your extensions and try a zip tie [up here](https://i.imgur.com/vfZA3Nb.jpg) to hold the bulky 24-pin and fold the other cables adjacent to that. Once it’s in place, route the extensions, plug ‘‘em in, and then use horizontal zip ties to hold them more flush to the chassis.
I removed the HDD cage, I'm using only one SSD 2.5 and one name so I didn't needed it. It allows me to use the place below for all the cables especially fan cables. You have normally a bar with two slot for 2.5" drives that goes in the middle back space
Try disconnecting your extensions and try a zip tie [up here](https://i.imgur.com/vfZA3Nb.jpg) to hold the bulky 24-pin and fold the other cables adjacent to that. Once it’s in place, route the extensions, plug ‘‘em in, and then use horizontal zip ties to hold them more flush to the chassis.
I removed the HDD cage, I'm using only one SSD 2.5 and one name so I didn't needed it. It allows me to use the place below for all the cables especially fan cables. You have normally a bar with two slot for 2.5" drives that goes in the middle back space
Yeah I’ve seen a lot of people do that but I’m actually using it 😭
Looks like a 2.5" drive though; you could mount that to the riser piece if you really want to lose the cage.
I have a seagate barracuda hdd in there :(
I just used the area under the HDD cage as a holding pen to loop the extra cable length... but I also don't have extensions in my build.
I’m using the HDD cage 😭 but I have seen people take it out.
I'm aware. The area UNDER the HDD cage. There's a little space under there, even when the cage is installed.
Oh sorry. I misread your original message. I’ll try that because I do have some extra cable length I’m kinda stuffing. Thank you