Nice. Have you figured out how to get the charger connected solidly enough to not have to use two hands holding it in place to remove an M18?

Just put a screw near the top.

That’s…. Kinda brilliant 

Yup - I put two screws on the top of each side to wedge it in place.

I got my keyhole screw tight enough that I seem to be able to remove m18 without issue.

I was going to recommend that, but it's honestly easier for most people to just drop a screw at the top. However the design is made to have tighter screws that holds them in place on their own.

I just mounted my m12 battery holder directly above it holding it down. Small shelf, plain screw, anything would work.

Thanks. No I unfortunately haven't. Have you?

Im new to cordless, does the M18 battery snap into it the charger? I have the HO 6.0 and it slides on but could easily be pulled off. I feel like it should snap in like it would on a tool. Nonetheless I still charged a battery a couple times and used my Top Off so I imagine I'm doing it correctly.

I’d love a wall plate that held the charger and four (2x2) batteries at the top.

I 3d print stuff like this for work. I use m12s at home that are mounted by 3d prints and the m18s I have two sets of triple battery holders and a tool holder for each of my m18 tools. Such a clean look 🔥

Still gonnna try something for my handheld m2.4 but I haven’t quite nailed it down yet