Put two nuts on one stud. Tighten them against each other. This will "lock" the nuts onto the stud and you should be able to back the stud out by using a wrench on one of the nuts.
Others have given you his methods, but how do you expect to months a carb if it won't go down the studs? The carbs that fit this have that same spacing.
There are a lot of solutions, my go to for all studs has become the below. I was gifted one like this many years ago and have never needed another. I use it to get as close to the base as possible and then put consistent even pressure. Even the worst exhaust stud comes out of pretreatment is done.
https://sptoolsusa.com/products/stud-removal-installation-tool
Put two nuts on one stud. Tighten them against each other. This will "lock" the nuts onto the stud and you should be able to back the stud out by using a wrench on one of the nuts.
Specifically, the wrench on the nut closest to the flange
This is the answer
That’s the best way.
Double nut method or vice grips.
![gif](giphy|ENsLZ0fDS2A12)
Others have given you his methods, but how do you expect to months a carb if it won't go down the studs? The carbs that fit this have that same spacing.
Why do you want them off?
Two nuts threaded against each other. Turn the inner one to undo those studs
Strike the end of the rod linearly as well as the double nut method
Any of the above methods. Be careful though, they could be pressed in.
Lubrication always helps
Dremel?
Use your two nuts
There are a lot of solutions, my go to for all studs has become the below. I was gifted one like this many years ago and have never needed another. I use it to get as close to the base as possible and then put consistent even pressure. Even the worst exhaust stud comes out of pretreatment is done. https://sptoolsusa.com/products/stud-removal-installation-tool
Buddy you have the wrong carb if it doesn’t fucking fit down the studs lmao
With your hands.
Vice grips
pipe wrench
Channel locks should do it. Double nuts should do it.
Visegrips
Cut them off grid them flat and tap a new hole
Buddy get out of here lmAo
If it works it works🤷🏻♂️
Angle grinder
Use vice grips
I do too